STEP- BY- STEP PHOTO INSTALLATION GUIDE
home045015.gif
One of the most common questions referring our Boost Bottle kits is Installation. We offer Pre-tapped manifolds built by
Our shop technicians. This eliminates the hassle associated with installing the Boost Bottle kit. Please allow some time
for the photos to load. Engine used in Photos: Zenoah G260RC 25.4cc Engine. Boost bottle used in Installation: Billet
Team Edition Kit with Pre-tapped manifold.
home045014.jpg
home045013.gif
1. Tools needed: Philleps head screwdriver, size 4 alan wrench (hex key)
home045012.jpg
home045011.gif
  1. Remove your carburetor using your hex key.
home045010.gif
home045009.jpg
3. Remove your manifold. (What your carb screws were bolted into).
home045008.gif
home045007.jpg
4. Place the manifold that came with your Boost Bottle kit directly where your stock manifold was. (Just like picture)
home045006.jpg
home045005.gif
5. Observe bolted on manifold.
home045004.jpg
home045003.gif
6. Replace your carburetor.
home045002.gif
home045001.jpg
7. Mount bottle(s) where you like and Go!
COPYRIGHT© 2008 BOOST INDUCTION SYSTEMS INC. U.S.A ALL RIGHTS RESERVED.